Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateWhy Hialeah Gardens Homeowners Choose Ghost Controls Gate Repair
We provide independent Ghost Controls gate repair service in Hialeah Gardens, FL, and we work on these operators every week. What sets our Ghost Controls work apart is that we diagnose the board, battery platform, and arm as one system, not three separate mysteries. So when a TDS dual-swing starts losing sync or an AXSBT battery quits holding charge after a storm, we already know where to look. Call us at (855) 360-5306 for a free estimate on any Ghost Controls issue in the 33012 area.

Let’s be direct about one thing: Archway Gate Repair is an independent service provider. We are not authorized, sponsored, or endorsed by Ghost Controls. Nelson Arrieta, our owner, has spent over two decades working on gate operators across Miami-Dade, and part of that time has been focused on Ghost Controls swing and slide systems specifically. What that independent status means for you is simple: we recommend what the gate actually needs, not what a manufacturer’s warranty flowchart says should happen next.
Hialeah Gardens homes and commercial lots along the Palmetto Expressway and Okeechobee Road take a beating from humidity, salt air, and June-through-November storm cycles. Ghost Controls operators hold up well, but the South Florida environment exposes their known weak points faster than almost anywhere else. We see those failures daily. If we’ve seen the brand, we’ve already seen the problem.
Why Trust Archway Gate Repair for Your Ghost Controls Gate Repair?
Ghost Controls builds its reputation on battery-driven and solar-ready swing and slide operators that suit South Florida’s frequent power interruptions. The tradeoff is that these systems rely on control boards, sealed battery packs, limit switches, and arm pivots that all interact. A general handyman sees a gate that won’t move. We see a TB-series board not communicating with a degraded AXSBT pack, or a slave arm that lost its limit signal after a voltage dip during a July thunderstorm.
Nelson Arrieta grew up near Norwood in Miami Gardens, and he took electrical systems and industrial mechanics coursework at Miami Dade College’s North Campus before spending years on gate brands across South Florida, from rusted swing arms on older HOA properties to modern linear actuators along NW 183rd Street. We also provide Ghost Controls service in Miami Gardens. That background means our team reads Ghost Controls wiring diagrams the way a mechanic reads an engine bay. The diagnosis starts before we open the control box.
We stock genuine Ghost Controls control boards, arms, and battery/solar kits for the models most common in Hialeah Gardens. When OEM parts matter for board logic or actuator gearing, we use them. When quality aftermarket hardware does the same job for less, such as low-voltage wire, conduit, remotes, or keypads, we tell you and let you decide. You always get the price before we start work.
Styles & brands we work with





Common Ghost Controls Gate Repair Problems We Fix in Hialeah Gardens
- Dead or reset-looping control boards after lightning and brownouts. The TB-series board stops responding to remotes and the keypad, but the arm still cycles manually. We see this pattern after South Florida’s violent summer electrical storms and the brownouts that follow. Often the board’s power regulation circuit took a hit while the actuator itself remains perfectly fine. We test the board before condemning it, because a reset loop is sometimes recoverable with a proper reconfiguration rather than a full board replacement.
- Battery pack degradation and solar-charge failure on AXSBT systems. The gate slows to a crawl or reverses mid-travel. In Hialeah Gardens, the combination of afternoon heat, heavy cloud cover, and salt-laden humidity shortens battery life faster than the manufacturer’s generic estimates suggest. The AXSBT pack simply can’t recover its charge capacity in those conditions. We replace the pack and verify the solar panel’s output, so you’re not buying a new battery every August.
- Limit-switch and arm pivot wear on dual-swing setups. One gate leaf stops short, overshoots, or the two operators fall out of sync entirely. Ghost Controls TDS-series dual-swing systems rely on both arms agreeing on their open and closed positions. When a limit switch corrodes or a pivot develops play, the slave arm loses its reference point. We clean and reseal terminals, reset limits, and when the pivot is wallowed out, we replace the arm before it bends.
- Moisture intrusion and terminal corrosion at the control box and actuator connectors. Rainy-season humidity causes intermittent open/close behavior or phantom activations, which is a security concern for any Hialeah Gardens homeowner. Ghost Controls control boxes seal well when installed correctly, but several years of exposure and occasional pressure-washing around the gate post can compromise the gasket. We open the enclosure, dry and clean the board, replace corroded terminals, and reseal the box properly.
- Solar panel underperformance from debris and angle drift. A 50W or 100W Ghost Controls panel that was installed at the wrong angle, or has accumulated grime and tree debris, won’t keep the AXSBT battery topped up. That weakens the entire system over time. We test actual panel output in full sun, clean or re-angle the panel, and confirm the charge controller is doing its job. This is a maintenance item most owners never think about until the gate fails at the worst moment.
Ghost Controls Parts & Our Repair-vs-Replace Approach
We fit genuine Ghost Controls control boards, arms, and battery/solar kits where they matter most, including board logic and actuator gearing. Those are the components where aftermarket substitutions create more problems than they solve. For low-voltage wire, conduit, keypads, remotes, and mounting hardware, we use quality aftermarket parts that perform identically for less money. You get a line-item quote before any work starts, so the decision is always yours.
Our repair-first philosophy guides every Ghost Controls job. If a board is fried but the arm gearing and post are sound, we repair. If the actuator housing is cracked with water intrusion or the pivot is wallowed out, we tell you straight that replacement is the better money. Nobody wants to spend $900 replacing an arm when a $40 limit switch and a reseal fixes the problem. And nobody wants to patch a cracked housing twice a year either. We give you the honest call either way.
Most common Ghost Controls parts for Hialeah Gardens systems are available to us quickly, and we keep the high-failure items on hand, including TB-series boards, AXSBT battery packs, limit switches, and remotes. That means many repairs happen same-day. Call (855) 360-5306 and tell us what your gate is doing, and we’ll tell you what we think it needs before we even roll out.
Our Ghost Controls Service Process – Step by Step
- 1
Diagnosis on site. We test the control board, battery voltage under load, limit-switch continuity, and arm operation as a complete system. On Ghost Controls units, the board, battery, and arms fail in predictable ways, so we check each function in the order that matches your symptom. You see the diagnosis and the price before we turn a single screw for the repair.
- 2
Repair or replacement with the right parts. We use genuine Ghost Controls components for board and actuator work, and quality aftermarket parts for wire, conduit, remotes, and keypads. We do so with an eye toward Miami-Dade’s product-approval requirements when structural anchors or operator components need replacement, which matters for Hialeah Gardens properties with hurricane-rated rolling and sliding gates.
- 3
Full-cycle testing. We run the gate through repeated open and close cycles, test the safety sensors (photo-eyes) at multiple approach angles, and verify battery charging under load. On dual-swing systems, we confirm both leaves reach their limits and stay in sync. On solar setups, we check panel output and charge controller function.
- 4
Warranty on our work. We stand behind what we repair and install. If the same symptom returns shortly after our repair, we come back. Your gate should work when you press the remote, every time, rain or shine. If you have questions after we leave, call us. We answer.
See the difference
Before
After
Before
After
Before
AfterGhost Controls Products We Service & Install in Hialeah Gardens
We work on the full Ghost Controls residential lineup that dominates Hialeah Gardens driveways and pedestrian entrances. That includes the Heavy-Duty Dual Swing series (TDS), the Single Swing series (TS), the Slide Gate Operator line (AXS/AXSL), and the Solar & Battery Kit platform built on the AXSBT battery with 50W to 100W solar panels. Whether your gate is a wrought-iron swing on a 33012 single-family home or a sliding gate on a commercial lot off Okeechobee Road, we know the operator that drives it.

We stock the parts that fail most often in this climate: TB-series control boards, AXSBT battery packs, limit switches, remotes, keypads, and solar charge components. If we don’t have it on the truck, we can usually get it the same week. What we won’t do is sell you a part you don’t need. The quote comes before the work, and the work comes before the invoice.
We Also Service These Brands
While this page focuses on Ghost Controls, Archway Gate Repair is not a single-brand shop. We carry hands-on experience with LiftMaster, Mighty Mule, and DoorKing systems as well, plus FAAC, BFT, Linear, Viking, and Elite. That multi-brand depth means we see the differences between operator platforms clearly, and we don’t force a one-size-fits-all fix onto your gate.
FAQs – Ghost Controls Gate Repair Service in Hialeah Gardens
No. We are an independent Ghost Controls service provider, not an authorized dealer or warranty center. That independence lets us recommend repairs based on what your gate actually needs rather than what a warranty protocol dictates. Call (855) 360-5306 and we’ll tell you what we’d do if it were our gate.
Yes, where they matter. We fit genuine Ghost Controls control boards, arms, and battery/solar kits for board logic and actuator gearing because those components are engineered as a system. For low-voltage wire, conduit, remotes, keypads, and mounting hardware, we use quality aftermarket parts that perform the same for less. You know exactly which parts go on your gate before we start.
Not necessarily. The beep often means the board is receiving power but has lost its configuration or is in a fault state after a voltage surge. We test the board’s power regulation circuit and its communication with the arms before declaring it dead. A reset loop is sometimes recoverable with a proper reconfiguration, but if the board is genuinely fried, we replace it with a genuine Ghost Controls unit. Call (855) 360-5306 and describe the beep pattern if you can; it helps us diagnose faster.
This is almost always an AXSBT battery pack that has lost its charge capacity, combined with reduced solar output from cloud cover and panel debris. The pack can’t hold enough charge to run the full cycle under load, so the gate slows or reverses as a low-voltage safety response. We replace the pack if needed, test the panel’s actual output, and confirm the charge controller is working. In Hialeah Gardens, this is one of the most common Ghost Controls issues we see between June and October. The same pattern shows up in nearby areas, and we offer Ghost Controls service in Lake Lucerne as well.
Yes. Out-of-sync dual-swing arms are usually a limit-switch or pivot issue on one leaf, not a board fault. We clean and reseal terminals, reset limits, and replace any arm pivot that has developed play. Both leaves get full-cycle tested after the repair to confirm they open and close in sync. If the pivot is wallowed out, we’ll tell you replacement is needed rather than patching it. Call (855) 360-5306 and we’ll schedule the sync check.
Often yes. Water intrusion causes intermittent shorts and phantom activations, but the board itself may be salvageable if we dry and clean it promptly. We open the enclosure, remove moisture, replace corroded terminals, and reseal the box properly. The longer it sits wet, the more likely the board fails completely. Call us as soon as you notice it misbehaving, and we’ll come out to Tri-County or anywhere in Hialeah Gardens to assess it. We also cover Ghost Controls in Scott Lake. Estimates are free.
Ghost Controls gate repair in Hialeah Gardens typically costs between $250 and $650 for common issues like limit-switch replacement, battery pack replacement, or control-board repair. Full board replacement with a genuine Ghost Controls unit tends to run $400 to $700 including labor, depending on the model and access. Dual-swing arm work and solar panel replacement sit at the higher end. Every quote is line-itemed and agreed before we start work, so the invoice matches the estimate. Call (855) 360-5306 for an exact price on your specific issue.
Book Your Ghost Controls Service in Hialeah Gardens, FL
If your Ghost Controls gate is misbehaving, call us at (855) 360-5306. We’ll ask what it’s doing, give you a straight read on the likely cause, and schedule a visit that fits your day. Free estimates, upfront pricing, and a diagnosis you can trust. We work on Ghost Controls gates all over Hialeah Gardens, from the neighborhoods off West 16th Avenue to the commercial lots along Okeechobee Road. Our coverage extends to Carol City Ghost Controls service too.
Written by Nelson Arrieta, Owner at Archway Gate Repair, serving Hialeah Gardens and surrounding Miami-Dade communities with independent Ghost Controls gate service and repair.