Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Parkland, FL
Gate installation in Parkland is a different animal than most of Broward County. We’re not hanging a standard driveway opener on a zero-lot-line lot. We’re out in Pine Tree Estates and the Ranches, working with wrought-iron estate gates, cedar ranch gates, and long private driveways that see horse trailers and farm equipment every day. Heavy duty hardware, custom posts, low-voltage or solar power runs across wide setbacks: that’s the baseline for Parkland work. If your gate needs replacing or first-time installation, call Archway Gate Repair at (855) 360-5306.
Why Parkland Homes Are Different
Parkland’s 33067 ZIP covers two very different gate realities. East of University Drive, you’ll find newer gated communities where the operator is standard LiftMaster or FAAC equipment, and the failure is usually a bad control board or a tripped safety sensor. West of University, especially around Pine Tree Estates and the Ranches, the picture changes completely. Those properties sit on one-acre-plus lots, often zoned for horses, with long private driveways shared by family vehicles, trailers, and occasional farm equipment. The gates there are heavier, wider, and frequently solar or low-voltage powered, because running 120-volt line power to a gate 200 feet off the road is expensive and disruptive.
South Florida’s salt-laden humidity and afternoon thunderstorms do real damage to gate electronics here. We see corrosion on control boards and hinge posts all year, but the worst is August through October, when daily lightning storms take out openers and safety sensors across Parkland in a single afternoon. Surge protection and battery backup are not upsell items here. They’re the difference between a gate that works after a storm and one that leaves your property open. Parkland homes also tend to have gates installed with the house, which means Pine Tree Estates gates from the early 2000s are now 15 to 25 years old and reaching the end of their control boards and swing arms. That’s our bread and butter.
Styles & brands we work with
Our Main Parkland Services
Most Parkland calls to Archway Gate Repair fall into two categories: gates that stopped working and electric systems that behave erratically. Both are covered by the two pages below.
Gate Repair in Parkland
When a gate in Parkland won’t open, won’t close, or grinds halfway and stops, the cause is usually mechanical wear or a failed component that’s been corroding quietly for years. In the Ranches, we regularly find worn tracks and undersized operators from decades of heavy daily use by horse trailers and large vehicles. In Pine Tree Estates, the issue is more often a hinge post that’s sagged or a swing arm that’s finally given out. We diagnose the full system, from the motor to the hinge, and quote the repair before any work starts. Gate Repair in Parkland covers the specifics, including pricing for common failures.
Electric Gate Repair in Parkland
Electric gate repair is the majority of what we do in Parkland because nearly every property here has an automatic opener. Motors burn out. Control boards fail after lightning. Safety loops stop detecting vehicles. Wiring corrodes inside conduit. Archway Gate Repair works on the brand already on your property, including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. We’re factory-familiar with each system’s failure points, so diagnosis is fast and we’re not guessing with your parts budget. Electric Gate Repair in Parkland has the full breakdown.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Parkland
Gate installation in Parkland almost always involves a custom fit, not a kit. The lot sizes, the setback from the road, the equestrian traffic in the Ranches, and the HOA aesthetics in gated communities all shape the design. We install gates that hold up to salt humidity, daily heat, and hurricane-season power issues, sized correctly for the traffic they’ll actually see. Archway Gate Repair offers full Gate Installation for Parkland properties, from first post hole to final safety sensor calibration.
Automatic Gate Installation
Signs you need it
You’re replacing a manual gate or an opener that has failed beyond economical repair, and you need the gate to open hands-free for vehicles and delivery traffic.
What it costs in Parkland
Automatic gate installation in Parkland typically runs from $1,800 to $6,500 depending on gate size, operator type, and whether you need a solar or low-voltage power setup.
How we do it
We survey the driveway width, choose an operator rated for the gate’s weight and daily cycles, set the posts, mount the operator and safety sensors, and program remotes and keypads on site.
Driveway Gate Installation
Signs you need it
Your existing gate is too narrow for trailers or large vehicles, rusted beyond repair, or you’re adding a first gate to an open driveway in the Ranches or Pine Tree Estates.
What it costs in Parkland
Driveway gate installation in Parkland typically starts at $2,500 and can reach $8,000 for wide, heavy estate gates with custom posts and automation.
How we do it
We set the posts at the correct width for your largest vehicle, hang and level the gate, and run power or install a solar panel and battery bank depending on the distance from the house.
What Gate Installation Costs in Parkland
| Item | Typical range in Parkland |
|---|---|
| Automatic gate installation | $1,800 – $6,500 |
| Driveway gate installation | $2,500 – $8,000 |
| Sliding gate installation (wide openings) | $3,000 – $9,500 |
Does a new Parkland gate need a permit?
Many Parkland gate installations need a permit, especially when electrical work is involved or the gate sits near a public right-of-way. Archway Gate Repair handles the paperwork and schedules inspections. Call (855) 360-5306 and we’ll check your specific property.
Can you match my HOA’s gate style?
Yes. We work in Parkland gated communities regularly and fabricate or source gates that match the community’s approved aesthetic. We’ll pull the HOA guidelines before quoting so you’re not fighting the board later.
Brands We Service in Parkland
We stock parts for LiftMaster, FAAC, Mighty Mule, and Elite operators, which covers a large share of the Parkland gates we see. That means most control boards, swing arms, and safety sensors are on the truck or a day out, not a week. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Parkland, FL
| Service | Typical range in Parkland |
|---|---|
| Automatic gate installation | $1,800 – $6,500 |
| Driveway gate installation | $2,500 – $8,000 |
| Sliding gate installation | $3,000 – $9,500 |
| Gate opener repair | $225 – $550 |
| Control board replacement | $350 – $900 |
| Safety sensor replacement | $150 – $400 |
| Swing arm or linear arm replacement | $425 – $1,200 |
| Hinge or wheel replacement | $200 – $600 |
| Full electric gate diagnostic | $95 – $175 |
What pushes a Parkland gate job up in price is almost always the distance from the house to the gate. Long wire runs, solar panel upgrades, and trenching through limestone soil add labor and material. Whatever the number is, you’ll see it and approve it before any work begins.
Neighborhoods We Serve in Parkland
We work across all of Parkland’s 33067 ZIP code, with regular calls from the following areas. Our response time for the entire city is typically same-day or next-morning depending on when you call.
- Pine Tree Estates
- The Ranches
- Parkland Golf & Country Club
- Cypress Head
- Heron Bay
Service Area – Cities Near Parkland
Archway Gate Repair handles gate work throughout northwest Broward. If you’re in Coral Springs, FL, Sandalfoot Cove, FL, Margate, FL, or Pompano Beach, FL, we can typically schedule you the same week. Parkland residents get priority same-day scheduling because our techs are already in the area.
Serving Parkland, FL — Our Local Coverage Area
We’re based in the Parkland area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Parkland
Same day in most cases. We keep techs routed through northwest Broward daily, so a morning call from Pine Tree Estates or the Ranches usually gets an afternoon visit. Emergency calls for a gate stuck open are prioritized.
For repairs, almost never. If you’re replacing a visible gate or changing its style, your HOA may need to sign off. We’ll tell you if your job is repair-level or replacement-level before you start, so you know whether to involve the board.
Yes. Solar and low-voltage systems are common in the western part of Parkland where line power isn’t practical. We diagnose panel, battery, and charge controller issues as part of our standard electric gate repair service, and we stock Mighty Mule solar components specifically because they’re so common out there.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Parkland Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Rohan Sharma"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
— Laura Schaefer"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Danika Ellison