Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in East Naples, FL
Gate installation in East Naples means engineering for salt air, canal-front lots, and gates that have to work every single time. Most homes here were built between the 1960s and 1990s, which means older openers, decorative aluminum frames, and keypads exposed to subtropical humidity for decades. Archway Gate Repair works on the brand already on your property, and we handle the full gate ecosystem from the motor to the hinge. If you’re planning a new install or replacing a system that’s finally given out, call (855) 360-5306 for a free estimate.
Why East Naples Homes Are Different
East Naples (34102) sits at the center of Naples’ canal-and-gulf-access waterfront, where nearly every driveway ends at a private dock or lift. That changes gate work in ways you do not see inland. The same salt air that pits an aluminum gate frame will usually kill an opener’s control board or keypad within a few seasons. Technicians here learn to check the operator and wiring for corrosion before ever touching the gate itself. Most properties are 1960s to 1990s single-family homes, villas, and low-rise condos on canal lots, many with decorative aluminum or wrought-iron driveway gates, side-yard privacy gates, and dock access gates. Those installations almost always pair with older electric openers that predate modern safety features. Add in subtropical Gulf-coast humidity, year-round salt air from the canals, and intense UV, and you get hinges, rollers, latches, and operators that corrode and seize far faster than they would in a drier climate. Summer afternoon thunderstorms and the occasional tropical system create wind-load and power-surge failures on automated gates. A gate that worked fine in April can be dead by August, and the failure is usually in the operator and hardware, not the gate itself.
Styles & brands we work with
Our Main East Naples Services
Two calls dominate the phones here: mechanical gate failures and electric systems that have stopped responding. Each one has its own page for East Naples because the scope of work, diagnosis process, and parts involved are different enough to matter.
Gate Repair in East Naples
Mechanical gate repair in East Naples means hinges seized with salt corrosion, sagging ornamental iron, latch plates that no longer align, and rollers that grind against pitted tracks. We work on driveway gates, side-yard privacy gates, and dock access gates. A common local failure is a wrought-iron gate that has settled on its posts after years of canal-side soil movement, leaving it dragging across the concrete. Archway diagnoses the actual cause before touching a wrench, because replacing a hinge on a misaligned gate without fixing the settled post just means doing it again next season. For the full breakdown of mechanical gate repair in East Naples, see Gate Repair in East Naples.
Electric Gate Repair in East Naples
Electric gate repair is the core specialty here, not an add-on. Wiring, control boards, motors, and safety sensors are all within scope. In East Naples, we see control boards corroded from salt air intrusion, keypads with buttons that no longer register because the contacts have oxidized, and motors that trip their thermal overload after a summer thunderstorm power surge. We work on the brand already on your property, which means we arrive knowing the failure points of your specific system instead of reverse-engineering from scratch. Read the full electric repair scope at Electric Gate Repair in East Naples.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in East Naples
Gate installation in East Naples starts with one question: what is the gate actually doing for you? On canal-front properties, it’s usually securing a driveway while standing up to salt spray and wind. On side yards, it’s controlling pedestrian access to a dock or lift. On commercial lots, it’s managing vehicle flow with an automated system. The housing stock here, mostly 1960s through 1990s construction, means many existing gates are outdated and under-engineered for the climate. We install gates that hold up in this environment, using hardware specified for coastal corrosion and operators sized for the gate’s actual weight and wind exposure. For a deeper look at how we approach new installs, see Gate Installation.
Automatic Gate Installation
Signs you need it
A manual gate that gets opened and closed multiple times a day becomes a chore, and on East Naples canal lots it also means leaving the property less secure than it could be.
What it costs in East Naples
Automatic gate installation in East Naples typically ranges from $3,500 to $9,500 depending on the gate size, operator type, and whether power already reaches the gate location.
How we do it
We survey the existing gate or gate opening, spec an operator matched to the gate’s weight and wind load, run or confirm the power supply, install the motor and controls, then set travel limits and safety sensors before testing under load.
Driveway Gate Installation
Signs you need it
A driveway gate that drags on the concrete, has rusted through at the bottom rail, or no longer matches the security needs of the property is a candidate for full replacement.
What it costs in East Naples
Driveway gate installation in East Naples starts around $4,000 and can reach $12,000 for larger aluminum or wrought-iron gates with automation included.
How we do it
We measure the driveway opening, account for slope and drainage, set new posts at the correct depth, hang the gate, and then install or integrate the opener and safety edges.
Sliding Gate Installation
Signs you need it
Properties with short setbacks or driveways that slope toward the street often cannot accommodate a swing gate, making a sliding gate the practical choice.
What it costs in East Naples
Sliding gate installation in East Naples typically runs $5,000 to $13,000, with commercial-width gates and heavier operators at the upper end.
How we do it
We set the track or cantilever system, hang the gate, install the drive motor and rack, then program travel limits, safety loops, and any keypad or intercom controls.
What Gate Installation Costs in East Naples
| Item | Typical range in East Naples |
|---|---|
| Automatic gate installation | $3,500 – $9,500 |
| Driveway gate installation | $4,000 – $12,000 |
| Sliding gate installation | $5,000 – $13,000 |
Every installation price is quoted and agreed up front, before any work begins. We do not spring a revised total on you after the posts are set.
Do you handle the power run and the safety edges?
Yes. We run or verify dedicated power to the operator, install safety edges and photo sensors, and make sure the gate reverses properly on obstruction. The full system leaves our hands tested under load, not just bolted in place.
Can I replace just the gate and keep my existing opener?
Sometimes, if the opener is in good condition and rated for the new gate’s weight. In East Naples, we frequently find the opener is the component that has aged worst, so we always assess both together before recommending a path. Call (855) 360-5306 and we’ll tell you straight.
Brands We Service in East Naples
We arrive knowing the failure points of the brand already on your property. In East Naples, we routinely service BFT, Linear, Viking, and Ghost Controls systems, along with LiftMaster, FAAC, DoorKing, Elite, and Mighty Mule. Common boards, remotes, and safety-edge parts are kept on the truck, which shortens turnaround noticeably on standard failures. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in East Naples, FL
| Service | Typical range in East Naples |
|---|---|
| Automatic gate installation | $3,500 – $9,500 |
| Driveway gate installation | $4,000 – $12,000 |
| Sliding gate installation | $5,000 – $13,000 |
| Electric gate motor replacement | $700 – $2,200 |
| Control board replacement | $450 – $1,400 |
| Keypad or intercom replacement | $350 – $1,100 |
| Gate hinge and roller repair | $250 – $900 |
| Safety sensor repair or replacement | $300 – $800 |
| Full gate and operator replacement | $4,500 – $14,000 |
Salt-air corrosion is the biggest price driver in East Naples. A board or motor that has been breathing canal air for fifteen years is often the real reason a gate stops, and replacing it right the first time is cheaper than piecemeal parts swaps. Every job is priced and agreed before work starts, no ambiguity and no back-end surprises.
Neighborhoods We Serve in East Naples
We cover the full 34102 footprint in East Naples, from the canal-front communities around the Gordon River to the villa and condo clusters south of Davis Boulevard. Our dispatcher routes calls so a technician can typically reach most East Naples addresses the same day or early next morning.
- East Naples Bay
- Bayshore Arts District
- Haldeman Creek
- Rock Creek
- Shell Shores
Service Area – Cities Near East Naples
Archway Gate Repair serves East Naples and the surrounding communities throughout Collier County. We also run calls in Lely, FL, Naples Manor, FL, Naples, FL, and Golden Gate, FL. If your gate is down and you’re anywhere in the corridor, call and we’ll get you scheduled.
Serving East Naples, FL — Our Local Coverage Area
We’re based in the East Naples area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in East Naples
Most East Naples addresses in 34102 can be reached same-day or early next morning. If a gate is stuck open or a vehicle cannot get in or out, tell the dispatcher and we’ll prioritize the call. Call (855) 360-5306 and we’ll give you a straight arrival window.
Many canal-front communities in East Naples have architectural review requirements for gate style, height, and color. We’re familiar with those processes and can provide the specs and documentation your HOA will likely ask for. The gate work itself rarely requires a building permit, but replacement of an automated operator may need an electrical inspection depending on scope.
Yes. Dock and lift access gates are common on canal lots here, and they fail differently than driveway gates because they sit even closer to the water. Corrosion is more aggressive, and we check the operator, hinges, and wiring before the gate itself, because that’s almost always where the failure lives.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What East Naples Customers Say
"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Danika Ellison"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Chris Padgett"Gate stopped halfway and sat there for two days blocking the driveway. He found a dead capacitor in the operator, had one with him, and we were moving cars again in under an hour."
— Michelle Ackerman