Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Cape Coral
An electric gate that won’t open or close isn’t something you can put off until next week. In Cape Coral, where nearly every home sits on a canal or interior lot with a wide concrete driveway, your gate does real work every day. We’re Archway Gate Repair, and we fix gates for homeowners and property managers throughout Cape Coral, from the sailboat canals off 33914 to the neighborhoods east of Del Prado Boulevard. Our team works on the brand already on your property, so diagnosis starts the moment we pull up, not after an hour of guesswork. Call (855) 360-5306 and you’ll talk to someone who knows gates, not a call center.
Key takeaways:
- We repair Electric Gate Repair on all major brands, including LiftMaster, FAAC, BFT, DoorKing, and Mighty Mule.
- Cape Coral’s salt air and sandy soil create gate failures you won’t see 20 miles inland. We plan for them.
- Repair first, replace only when necessary. We’ll tell you honestly when a new operator costs less than nursing an old one.
- Free estimates over the phone. The price we quote is the price you approve, before any work starts.
Why Archway Gate Repair Is Cape Coral’s Preferred Electric Gate Repair Company
Most companies that fix gates in Cape Coral are fencing outfits or handymen who “do gates too.” We’re the opposite: a gate-only specialist led by Nelson Arrieta, with hands-on experience across nine of the most widely installed residential and commercial gate brands. That matters because when a Linear operator dies on a canal-front property, the answer isn’t “we’ll take a look and see.” We already know what typically kills that board in salty, humid air. We know what usually binds that track on sandy soil. Diagnosed, not guessed.
Cape Coral homes are different from those in Fort Myers or Naples. The city boomed in waves from the 1970s through the early 2000s, which means one street can have a 1985 slide-gate operator next to a 2019 smart opener. We’ve worked on all of it. From the motor to the hinge, we cover the full gate ecosystem, electric repair, manual repair, and full replacement when the numbers say it’s time.
We’re insured and bonded, and every job starts with a clear diagnosis and a written price before we turn a single wrench. No trial-and-error on your dime.
Styles & brands we work with
Automatic Gate Repair in Cape Coral
Automatic Gate Repair in Cape Coral usually means one of three things: a motor that hums but won’t move the gate, a control board that’s fried from humidity or a power surge, or a track and rollers that are fighting the gate because the soil underneath has shifted. Cape Coral’s heavy summer rains and hurricane-season wind do not help any of these problems. A typical automatic gate repair here runs $185 to $420 when it’s a motor or board fix. If the track needs resetting and the hinges need realignment, expect $240 to $500. We tell you the number before we start.
Slide Gate Repair
Slide gates are the most common automatic setup in Cape Coral because they fit the wide, shallow driveways the city was built around. The gate rolls on a steel track that sits in sandy soil, and after a few heavy rains that track settles unevenly. We shim it, reset the stops, and make sure the motor isn’t working double-time against a binding roller.
Swing Gate Repair
Swing gates sag. It’s not your hinges, it’s the post. Sandy soil in Cape Coral drains fast and shifts constantly, and a gate post that was poured too shallow leans incrementally until the gate scrapes the driveway. We address the post, not just the panel.
Electric Gate Motor in Cape Coral
Electric Gate Motor replacement in Cape Coral is a decision we help you make honestly. If your motor is less than eight years old and the failure is isolated, repairing the board or capacitor usually runs $180 to $350. If the motor has been grinding or the operator is over 15 years old and exposed to canal air, the repair may not hold. A full motor or operator swap typically lands between $750 and $1,400 depending on brand and gate size. We will never quote you a new operator just because we carry them. But we’ll also tell you when patching an old one is throwing money into a hole.
When to Repair the Motor
A motor that runs fine but intermittently won’t respond is often a control board issue, not a motor failure. Cape Coral’s humidity and salt spray kill boards before motors. We replace the board, seal the new one, and your operator keeps working.
When to Replace the Operator
If the gate is 20 years old, the manufacturer no longer makes the board, and corrosion has reached the internal wiring, you’re at the point where a new operator with safety sensors and current features costs less than three more service calls. We’ll show you the numbers and let you decide.
Trusted Brands We Service in Cape Coral
We’re factory-familiar with nine major gate brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. On this page we want to highlight three that we see constantly in Cape Coral. BFT operators are common on older swing gates in the 33909 and 33910 neighborhoods, and their boards are especially sensitive to humidity. Linear slide gate operators dominate mid-2000s construction. Viking and Ghost Controls both appear on canal-front properties where owners wanted reliable openers without spending on commercial gear. We keep common boards, remotes, and sensors stocked for these brands, which means less waiting when your gate is down.
Common Electric Gate Repair Problems We See in Cape Coral Homes
- Corroded control boards. Salt air from the canals gets into operator housings and eats circuit boards. In ZIPs 33904 and 33914, a board that fails at year 12 inland might fail at year 7 on a salt-water canal. We use sealed connectors and corrosion inhibitor on every canal-front repair.
- Sagging swing gates. Cape Coral’s sandy soil shifts after heavy rain. A gate post that was fine in March can lean half an inch by August. The gate scrapes, the motor strains, and eventually the panel cracks. Fixing the post is the only real answer.
- Track misalignment after storms. Wind-driven rain and soil movement knock slide gate tracks out of square. The gate starts binding mid-travel, and the motor trips its safety stop. We reset the track and the limit switches in the same visit.
- Dead or frozen keypads. Intense UV and humidity in Cape Coral break down keypad membranes. The buttons still click but the signal dies. We replace the keypad and seal the housing so you’re not doing this again in two years.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Cape Coral, FL
Here’s what you’re likely to pay in Cape Coral right now, based on the calls we run every week. Keypad replacement: $120 to $220. Safety sensor repair or replacement: $140 to $260. Control board replacement: $200 to $450 depending on brand. Motor repair: $180 to $350. Full operator swap: $750 to $1,400. Canal-front jobs in 33904 and 33914 sometimes run a bit higher because corrosion treatment and connector sealing are mandatory, not optional. The price we quote is the price you approve before any work starts. Call (855) 360-5306 and we’ll give you a real number over the phone.
We Also Serve Cities Near Cape Coral
Our Electric Gate Repair in Cape Coral team also covers Burnt Store Marina, Iona, Lochmoor Waterway Estates, and Palmona Park. If you’re just outside city limits and your gate is down, call us. We know these areas and we’re already on the road.
Serving Cape Coral, FL — Our Local Coverage Area
We’re based in the Cape Coral area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Cape Coral
If the board is still available from the manufacturer and the corrosion hasn’t spread to the main wiring harness or the motor windings, you can replace just the board. We apply corrosion inhibitor and sealed connectors on every canal-front repair in 33904 and 33914, which extends the new board’s life dramatically. But if this is the second or third board in five years, the salt is winning and a new operator with a sealed housing will cost less over the next decade. We’ll show you both numbers. Call (855) 360-5306 and we’ll diagnose it honestly.
Because the post is moving. Cape Coral’s sandy soil drains fast, and after heavy summer rain the ground under the post compresses. The post leans, the gate sags, and tightening the hinge band just shifts the stress elsewhere. We pull the post, repack it, and reset the gate. The panel itself is usually fine.
It depends on the brand and what’s failed. A 20-year-old Linear or BFT board is often no longer manufactured. You’re buying used parts, and used boards have already spent years in the same salty air that killed yours. At that age, a new operator with a warranty, modern safety sensors, and smartphone control usually runs $900 to $1,400. We will never push a replacement if we can get you two more good years from a $250 fix. But we’ll also be straight with you when you’re about to spend repair money on a gate that’s ready to retire.
Salt air corrodes the contact points inside keypads and fogs the lenses on photo-eye sensors. The keypad buttons stop registering, and the sensors start throwing false safety blocks. On canal-front homes in 33904 and 33914, we see keypads fail twice as fast as interior lots in 33910. We replace them with sealed units and add dielectric grease on the connectors. Takes about an hour. Call us at (855) 360-5306 and we’ll come out.
Almost always, yes. A storm knocks the track out of square or washes sand over it. We reset the track, shim it level, and realign the limit switches. If the rollers are corroded from salt spray, we replace those too, it’s a standard part, not a gate replacement. The job typically runs $240 to $400. Call (855) 360-5306 for an exact quote, estimates are free.
A homeowner in the Pelican neighborhood, ZIP 33914, called us after a 15-year-old LiftMaster slide gate operator died in a summer storm. The salt air had eaten the control board and the sandy soil had thrown the track out of line, so the gate bound up every time it tried to close. We replaced the board, reset the track, applied corrosion inhibitor, sealed the connectors, and had the gate running smooth again that afternoon. No new gate. No five-figure surprise.
Contact Archway Gate Repair in Cape Coral
If your electric gate is down, running rough, or just making a sound you don’t trust, call us. We’re reachable at (855) 360-5306 and we give free estimates over the phone. We service all of Cape Coral, from the canal-front streets of 33904 and 33914 to the family neighborhoods of 33909 and 33910. The price we quote is the price you approve. Nothing starts until you say go.
Written by Nelson Arrieta, Owner at Archway Gate Repair, serving Cape Coral and surrounding communities.