Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Plantation
Electric gate repair in Plantation typically runs $180 to $680 depending on whether it’s a control board, a motor, or a full operator swap. If your gate is stuck open, grinding, or dead after a storm, we can usually get a technician to your Plantation property the same day. Nelson Arrieta leads our team, and we work on the brand already on your property, so diagnosis starts before we even arrive. Call (855) 360-5306 for a free estimate.
Plantation’s gates sit in some of the toughest conditions in South Florida. Salt-laden humidity, hurricane wind loads, and saturated ground from summer rains punish operators, hinges, and control boards year-round. We know where Plantation gates fail because we’ve fixed hundreds of them across 33388, from the 1960s subdivisions off Sunrise Boulevard to the 1980s and 90s gated communities near Broward Boulevard and Pine Island Road. A gate that won’t close in Plantation isn’t a nuisance, it’s a liability and an HOA violation waiting to happen.
Our Electric Gate Repair team handles both residential and commercial systems, and we keep parts for the most common brands on our trucks when we head into Plantation. That matters when your opener fails on a Friday afternoon and the association is calling.
Why Archway Gate Repair Is Plantation’s Preferred Electric Gate Repair Company
Plantation property managers and homeowners call us because we’re gate specialists, not a fencing company that “also does gates.” We diagnose rather than guess. When a Plantation HOA manager describes a FAAC slide gate stuck mid-travel, our technician already knows the likely culprits: a baked control board, a corroded loop detector, or a limit switch that’s drifted. That brand familiarity means we show up with the right diagnostic plan, not a blank slate.
Our local reputation in Plantation is built on the two-part job every repair really is: restoring the operator and producing the documentation the HOA’s architectural review board will accept. Nelson Arrieta’s team has worked with enough Plantation associations to know what that paperwork needs to say. We write repair reports that hold up when the board asks why the gate was down for six hours.
Response time to Plantation from our Miami Gardens shop typically runs 60 to 90 minutes for emergencies, depending on traffic on I-595 or University Drive. For non-emergency diagnostics, we schedule within one to two business days. Estimates are free, and the price you’re quoted is the price you approve before we turn a single screw.
Styles & brands we work with
Gate Access Control in Plantation
Gate Access Control in Plantation means more than fixing the motor; it’s the entire chain of devices that decides who enters and who doesn’t. We handle keypads with failing rubber buttons, corroded loop detectors that stop reading cars, remote receivers that drop signal after storms, and safety sensors that strand gates open because they’ve been fogged by humidity or crusted with salt. If you’re in a walled community off Nob Hill Road or a condo cluster near Pine Island Road, you know the drill: the gate works fine until the board calls.
In a typical Plantation residential install, we repair or replace the access control components without ripping out a perfectly good operator. A straightforward loop detector replacement runs $250 to $450. Keypad rebuilds or replacements fall between $180 and $420. If you’d rather upgrade than patch, we can install a new access system, but we’ll tell you honestly whether that’s necessary.
Common Access Control Failures After Storms
Salt-laden air in Plantation eats at keypad contacts and photocell housings. We see slide gates that refuse to close because the safety loop reads a phantom car, or swing gates that reverse because a corroded sensor sends a false obstruction signal. These are known failure modes here, not mysteries.
Documentation for HOA-Controlled Entries
When we repair access control in any Plantation gated community, we provide a service record that names the equipment, the fault, and the fix. Association boards in Plantation expect that documentation as part of the job. A gate that works but lacks a paper trail is unfinished business.
Commercial Gate Operator in Plantation
Commercial Gate Operator work in Plantation usually involves slide gates at community entrances, lift gates at parking garages, or barrier-arm systems at office parks. We service Viking, LiftMaster, and FAAC commercial operators, among others, and we’re familiar with how Plantation’s humidity and storm surges punish them. A commercial operator that fails at a boundary wall on West Broward Boulevard can back up traffic for blocks. We prioritize that.
Commercial operator repair in Plantation starts around $400 and can run up to $900 or more when it involves a failed motor, a damaged limit-switch assembly, or a control board that shorted after a post-storm power surge. If you manage a commercial property in Plantation and your gate is down, we’ll send a tech who can speak both the electrical and the mechanical side of the problem.
Operators That Need Rebuilding, Not Replacing
We rebuild gate operators that other companies would scrap. In Plantation, where many commercial operators date to the 1990s and have been through twenty hurricane seasons, a new board and new capacitors can often keep an otherwise solid Viking or LiftMaster unit running for years.
Emergencies at Commercial Entrances
When the gate at your Plantation business or HOA entrance is stuck open or locked, call us. We’ll walk you through the safest way to secure the opening until a technician arrives. We keep common commercial operator parts in stock so we don’t have to order and wait while your property stays exposed.
Trusted Brands We Service in Plantation
We work on the brand already on your property. In Plantation, that’s commonly LiftMaster operators on residential swing gates, FAAC hydraulic operators on community entrances, and BFT or Linear units on older commercial gates. We keep local parts for these brands and understand their specific failure points. A LiftMaster control board that’s been soaked and baked by Plantation storms behaves differently than a FAAC hydraulic unit that’s lost pressure. Knowing the brand means knowing what to test first, which means you pay for diagnosis time, not guesswork.
Common Electric Gate Repair Problems We See in Plantation Homes
- Wind-loaded swing gates pulling loose from saturated footings. Plantation’s solid infill gates catch hurricane gusts like sails. The hinge post loosens, the gate sags, and the operator strains until it burns out. We fix the alignment and the operator, not just the symptom.
- Salt-corroded safety loops and photocells. The humidity that rolls through 33388 every afternoon deposits salt on gate sensors. Gates strand open or refuse to close because the safety system thinks a car is in the way.
- Post-storm power surges frying control boards. Many Plantation gates run on original 1980s or 90s circuit boards. After a surge, the gate may be stuck mid-travel with no safe manual-release procedure documented.
- Keypads with dead rubber buttons and corroded contacts. Older Plantation communities near Flamingo Road and Broward Boulevard still have the original keypads. Rubber buttons crack, contacts corrode, and codes stop registering.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Plantation, FL
Here’s what we charge in Plantation right now. Motor repairs or replacements run $300 to $900. Control board replacements run $280 to $650. Keypad repair or replacement runs $180 to $420. Safety sensor or loop detector repairs run $250 to $450. Full gate operator replacements start around $900 and can go to $2,200 for commercial systems. Every quote is written out before work begins, and you approve it before we touch a tool. No separate dispatch fee for Plantation callers, and estimates are free. Call (855) 360-5306 and we’ll give you an exact number for your gate.
We Also Serve Cities Near Plantation
Archway Gate Repair serves Plantation and the surrounding Broward County communities. If you’re in Fort Lauderdale, Broadview Park, Broward Estates, or Lauderhill, our Electric Gate Repair in Plantation team covers your area too. Same schedule, same parts, same reporting.
Serving Plantation, FL — Our Local Coverage Area
We’re based in the Plantation area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Plantation
Most Plantation gates have a manual release on or near the operator with a keyed access point. If you have a LiftMaster or FAAC operator, look for the release handle on the side of the motor housing. Turn the release, push the gate by hand, and secure it with the chain or lock if one is present. If you’re not confident, call us and we’ll talk you through it over the phone. We can also label your release mechanism clearly so the next outage isn’t a panic.
If your home sits in a Plantation community with a mandatory HOA, expect to submit a repair record to the architectural review board after any gate work. We provide that documentation as a standard part of every repair: equipment details, fault description, the fix, and parts used. We know what Plantation boards ask for because we’ve answered those questions for years.
South Florida’s saturated ground weakens gate post footings, especially on older Plantation subdivisions where the original install used shallow concrete. When the ground gets saturated after summer rains, the post shifts, the gate drops or sags, and the operator has to work twice as hard. We correct the alignment at the hinge post and, if the footing has truly failed, we’ll tell you the honest repair rather than just adjusting the hinges and leaving.
If your gate opens and closes erratically after a storm, if it grinds, or if it stops mid-travel and won’t respond to the keypad, your operator may need a new control board or motor. We’ll diagnose it before recommending replacement. In Plantation, where many operators are decades old, a post-storm failure is often a board that can be replaced for $280 to $650 rather than a full motor swap. We’ll show you the failed part, not just tell you it’s dead.
We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Our techs know the Plantation gates that run these brands and we keep common parts in stock. If your gate uses one of them, we already know how it fails and what it takes to fix it. Call (855) 360-5306 for a free estimate.
HOA Documentation: The Second Half of Every Plantation Gate Repair
In Plantation, gated communities aren’t just common; they’re the default. Nearly every home behind a gate is governed by a mandatory HOA, and that changes what a complete repair means. The operator must work, and the work must be documented to satisfy the architectural review board. We’ve had Plantation homeowners tell us they were charged association fines because a previous contractor fixed the gate but never produced a report the board accepted.
So we treat documentation as part of the repair itself. After a control board replacement on a LiftMaster swing gate in a Plantation community near Broward Boulevard, we don’t just leave the gate working. We leave a report that names the fault, the parts, the labor, and the confirmation that safety systems were tested. The board sees that the gate was down for a reason and that it was repaired to code. That’s the difference between a gate specialist and a handyman who “does gates.”
After a tropical storm knocked out power in a gated 1980s subdivision off Broward Boulevard, we found a LiftMaster swing gate operator with a soaked control board and a rack and pinion choked with salt corrosion. We dried and replaced the board, freed the rack, and performed a sag correction at the hinge post before walking the homeowner through the manual release and delivering the HOA-ready repair report. That’s a typical Plantation job for us: two repairs in one, plus the paperwork.
Written by Nelson Arrieta, Owner at Archway Gate Repair, serving Plantation with electric gate repair, gate motor repair, and gate access control.