Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Miami
Electric gate repair in Miami typically runs $180 – $680 for most on-site fixes, with control board replacement, rack and pinion work, or full operator swaps landing higher. The bigger variable in this city isn’t the part, it’s whether your gate was installed and anchored to Miami-Dade’s post-1992 hurricane code. We work that code every week. If your gate is down, stalled mid-span, or refusing the remote, call us at (855) 360-5306 and we’ll have a technician headed your way with the right parts for your exact operator.
Long driveways off Krome Avenue, iron gates fronting CBS-block homes in Little Havana, commercial operators on NW 20th Street warehouses. We’ve worked on all of them. The salt humidity is relentless here, the summer rain seizes hinges, and every named storm leaves a trail of bent tracks and anchor-pulled posts. That’s the reality of gate work in Miami, and it’s why brand familiarity and local code knowledge matter more than a generic toolbox.
Why Archway Gate Repair Is Miami’s Preferred Electric Gate Repair Company
Miami homeowners and property managers call us because we already know their gate system before we pull up. We work on the brand already on your property. LiftMaster, FAAC, BFT, Elite, Mighty Mule, DoorKing, Viking, Linear, Ghost Controls. Nine of the most widely installed gate brands in residential and commercial Miami, and our techs know each one’s specific failure points. That means the diagnostic happens in the first ten minutes, not after an hour of guesswork.
Nelson Arrieta built Archway Gate Repair around a repair-first philosophy. We don’t default to replacement quotes when a control board has a bad relay or a limit switch is out of adjustment. Diagnosis, not guesswork. If the operator can be brought back online safely and to code, we bring it back online. When replacement is genuinely the honest call, we tell you that too, and we quote it straight.
Our Miami customers also know we cover the full gate ecosystem under one roof. Electric gate repair, gate motor repair, opener repair, keypad repair, remote control repair, safety sensor repair, control board repair, plus manual gate work and new gate installation. One company, one call. No referral to a second shop for the wiring or the motor. That continuity matters when you need commercial access control working before the morning shift arrives.
For response time across Miami, from 33125 through Midtown and out toward the 33187 acreage belt, we’re typically on-site within the same day for emergency calls. Hurricane season pushes everyone’s schedule, and we staff accordingly.
Styles & brands we work with
Gate Access Control in Miami
Gate access control in Miami almost always means an automated sliding or swing gate tied to a keypad, intercom, remote, or card reader, and the job is to make sure the operator, safety loops, and control electronics all speak to each other cleanly. A typical access control repair on a residential Miami gate runs $220 – $450. Commercial jobs with multiple credentials, vehicle detection loops, and telephone entry systems usually land between $600 and $1,800 depending on scope.
What Gets Replaced or Repaired
Most access control service calls in Miami come down to three things: a keypad with corroded contacts from the salt air, a receiver board that stopped recognizing remotes, or a safety loop that’s been cut by driveway resurfacing or root growth. We test the low-voltage wiring, confirm the operator is receiving the open command, and replace only the failed component. No board-swapping guesswork.
When Miami HOAs and Businesses Call Us
HOA managers in gated sections of Coral Gables and property owners running industrial lots off NW 20th Street call when a stranger can walk through an open gate, or when tenants can’t get in at 6 a.m. Safety sensors and photo eyes are a code requirement on automated gates in Miami, and a gate that reverses on nothing or won’t close fully is an entrapment risk, not just an inconvenience. We take access control calls seriously because access is the entire point of the gate.
Commercial Gate Operator in Miami
A commercial gate operator in Miami is a heavier-duty unit, usually a slide gate operator, designed for higher cycles per day than a residential opener, and the repair involves checking the chain or rack drive, the limit switches, the motor capacitor, and the control board under real load. Commercial operator repair in Miami typically runs $400 – $1,200 on-site, and full operator replacement on a wide industrial slide gate can reach $2,500 – $5,000 installed, depending on gate length and weight.
Cycle Count and Duty Cycle Reality
Warehouse gates on NW 20th Street cycle dozens of times a day. A residential operator retrofitted onto a commercial gate will burn out its motor fast. We check the data plate, verify the unit is rated for the gate’s duty cycle, and if it isn’t, we tell you plainly. Repair first, replace only when necessary, but sometimes the necessary repair is putting the right operator on the gate in the first place.
Entrapment Protection and Miami Code
Miami-Dade code requires entrapment protection on every automatic gate. That means photo eyes, edge sensors, or both, tested and functional. After a storm or a gate strike, those sensors get knocked out of alignment, and a non-responsive safety edge is a serious liability. We re-aim, re-wire, and verify the sensor loop before we call the job done. This isn’t optional in Miami, and insurers check.
Trusted Brands We Service in Miami
Archway Gate Repair is factory-familiar with nine major gate brands, and that matters when a board fails. We stock common control boards, remotes, photo eyes, limit switches, and receiver kits locally for Miami customers. If you have a Mighty Mule on a driveway gate in Brownsville, a LiftMaster slide operator on a farm gate off Krome Avenue, or a FAAC unit swinging an HOA entrance in Coral Gables, we arrive knowing the wiring diagram. Brand-specific knowledge means faster diagnosis and fewer wasted parts. No trial-and-error on a gate we already understand.
See the difference
Before
After
Before
After
Before
AfterCommon Electric Gate Repair Problems We See in Miami Homes
- Solar gate systems undercharged on rural acreage driveways. When mains power is impractical to trench to a long Miami driveway, solar panels run the opener. But salt film on the panel, short winter days, or a weak battery bank leaves a heavy-duty slide operator stalling mid-span, and livestock or vehicles get stranded behind a half-open gate.
- Corroded steel operators and seized hinges from salt-laden humidity. Year-round salt air pits untreated steel and seizes hinge bearings on long rural entrances. We swap in hot-dip galvanized or aluminum hardware because anything less fails again in two seasons.
- Rack and pinion skipping after storm damage or driveway heave. Mature royal palms and gravel driveways shift over time, racking the track out of alignment. After a heavy rain, the rack and pinion skips under load, and the gate shudders or stops. We re-set the footing and realign the track, not just the operator.
- Anchor-pulled hinge posts flagged after a named storm. Miami-Dade’s high-velocity hurricane zone inspection catches gate anchorages that were never permitted to current code. We re-anchor with through-bolts or epoxy into sound concrete, and we do the work to the standard insurers actually check.
Pricing for Electric Gate Repair in Miami, FL
You’ll pay roughly $180 – $680 for most residential electric gate repairs in Miami. A keypad or remote receiver repair runs $180 – $300. Safety sensor realignment or replacement lands between $200 and $400. Control board replacement typically runs $350 – $900 depending on brand and whether it’s a single board or a full panel. Wide farm slide gate repair with track realignment on an acreage property off Krome Avenue can exceed $1,200 when post footings need re-setting. Commercial operator work runs higher. Every job is quoted and agreed before any work starts, and estimates are free. Call (855) 360-5306 for a straight number on your specific gate.
We Also Serve Cities Near Miami
Beyond Miami proper, our Electric Gate Repair team covers Allapattah, Brownsville, Coconut Grove, and Coral Gables regularly. If you’re in any of those communities or adjacent to the 33125/33101 corridor, you’re in our normal service area. Call (855) 360-5306 and tell us where the gate is, and we’ll have a tech en route.
Serving Miami, FL — Our Local Coverage Area
We’re based in the Miami area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Miami
Because trenching mains power down a long driveway off Krome Avenue or through the 33187 acreage belt can cost more than the gate operator itself. Solar gate opener systems are the practical choice on those properties, but they need clean panels, healthy batteries, and a properly sized charge controller to run a heavy slide gate. When those degrade under salt film or heat, the operator stalls mid-span. We service solar gate systems directly, including panel mount corrosion repair, and we re-aim safety photocells across the full gate span. Call (855) 360-5306 for a diagnostic visit.
Yes. Miami-Dade’s post-1992 Hurricane Andrew code is the strictest wind-borne debris and gate-anchoring regime in the country. Every exterior operator, track, and anchorage on an automatic gate is evaluated against high-velocity hurricane zone specs. Unpermitted or non-compliant gate work gets flagged at inspection or by insurers in ways Broward crews rarely face. We re-anchor to that code with through-bolts or epoxy anchors, and we document the work so it passes inspection.
Usually both, but the root cause is almost always the track or post footing. Salt humidity pits the rack, roots and gravel heave the driveway, and the rack and pinion falls out of alignment. The operator then stalls or shudders under load. We check the whole drive system from motor to hinge, re-set what moved, and replace the rack or pinion only if it’s actually worn. Call (855) 360-5306 and we’ll diagnose it on-site.
Miami-Dade requires functional entrapment protection on every automatic gate. That means photo eyes, safety edges, or both, tested and verified. A gate that closes on a car or a person because the sensors were knocked out of alignment is a code violation and an insurer’s problem. We re-aim, re-wire, and test every safety device before closing out the job. If yours isn’t responding, call us today.
We can. The old wrought-iron gates in front of 1950s – 70s CBS homes in the 33125/33101 corridor and Little Havana need through-bolts or epoxy anchors because the original lags are set in 60-year-old block that crumbles when removed. Newer aluminum and vinyl gates in the west and south Miami developments use bolt-on hardware and different track systems. We carry both weld and bolt-on service capability. That’s what a gate-only specialist does, whether you’re operating a manual iron gate or a full Electric Gate Repair in Miami automatic system.
Written by Nelson Arrieta, Owner at Archway Gate Repair, serving Miami since day one with a gate-only focus.